D-Link DKVM-IP1 User Manual page 107


SMTP Logging enabled
This allows the DKVM-IP1 is able to send event e-mails to the specified e-mail address.
These mails contain the same description strings as the internal log file, and the mail subject
will contain the event group of the log event. In order to use SMTP Logging, tick the SMTP
Logging Enabled checkbox, enter the SMTP Server (<server IP>: <port>), Receiver Email
Address, and Sender Email Address, then click the Apply button to save your changes.
Note: The SMTP Server must be reachable by the DKVM-IP1, and must require no
authentication.

SNMP Logging enabled
If this is activated, the DKVM-IP1 sends a SNMP trap to a specified destination IP address
every time a log event occurs. If the receiver requires a community string, you can set it in the
appropriate text field. Most of the event traps only contain one descriptive string with all the
information about the log event. Only authentication and host power events have their own
trap class that consists of several fields with detailed information about the event. To receive
SNMP traps, any SNMP trap listener may be used.
Here is an example of all generated events and their event groups:
Loggable Events and their Event Groups
Device successfully started
Board Reset performed by user...
Firmware upload failed.
No firmware file uploaded.
Uploaded firmware file discarded.
Firmware validation failed.
Firmware file uploaded by user...
Firmware updated by user...
Event
106
Event Group
Device
Device
Device
Device
Device
Device
Device
Device