Troubleshooting - Zanussi ZDI11004XA User Manual

3
To remove filters (B)
and (C), turn the han-
dle counterclockwise
and remove. Pull
apart filter (B) and
(C). Wash the filters
with water.
D
A
5
Put filter (A) to its ini-
tial position. Make
sure that it assem-
bles correctly under
the two guides (D).

Troubleshooting

The appliance does not start or it stops during
operation.
Before you contact the Service, refer to the in-
formation that follows for a solution to the
problem.
Alarm code
• The indicator of the set programme flashes con-
tinuously.
• The end indicator flashes 1 time intermittently.
www.zanussi.com
www.preciz.hu
A
4
Remove filter (A).
Wash the filter with
water.
6
Assemble filters (B)
and (C). Put them in-
to position in filter
(A). Turn the handle
clockwise until it
locks.
An incorrect position of the filters can
cause bad washing results and damage
to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, re-
move remaining parts of soil with a thin poin-
ted object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abra-
sive products, abrasive cleaning pads or sol-
vents.
Internal cleaning
If you regularly use short duration pro-
grammes, these can leave deposits of grease
and limescale inside the appliance.
To prevent this, we recommend to run long
duration programmes at least 2 times per
month.
With some problems, different indicators
flash continuously or intermittently at
the same time to show an alarm code.
Problem
The appliance does not fill with water.
23