Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZDI12001
Summary of Contents for Zanussi ZDI12001
- Page 1 User manual Dishwasher ZDI12001...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3... -
Page 3: Product Description
• Do not keep the appliance door open without supervi- Disposal sion to prevent to fall on it. Warning! Risk of injury or suffocation. • Do not sit or stand on the open door. • Disconnect the appliance from the mains supply. •... -
Page 4: Programmes
Indicators Start button Delay button Programme knob Indicators Description Washing phase indicator. Drying phase indicator. End indicator. Salt indicator. This indicator is off while the programme operates. Programmes Degree of soil Programme phases Duration Energy Water Programme Type of load (min) (kWh) Heavy soil... - Page 5 3. Fill the rinse aid dispenser. The dishwasher salt keeps the water softener clean and in good conditions. Refer to the table to adjust the water 4. Open the water tap. softener to the right level. It makes sure that the water 5.
- Page 6 4. To adjust the level of the water softener, press the Filling the rinse aid dispenser start button. Each time you press the start button you Caution! Only use rinse aid for dishwashers. Other go to the next level. products can cause damage to the appliance. 5.
-
Page 7: Daily Use
Daily use 1. Open the water tap. 2. Turn the programme knob until the programme mark- er is aligned with the programme you want to set. Make sure that the appliance is in setting mode. Refer to ’SETTING AND STARTING A PROGRAMME’. Set the correct programme for the type of load and soil. - Page 8 When you use tablets, that contain salt and rinse aid, do • The phase indicators of the set programme start to not fill the salt container and the rinse aid dispenser. The flash. rinse aid indicator always comes on if the rinse aid dis- 4.
-
Page 9: Care And Cleaning
2. Open the appliance door. • First remove the items from the lower basket, then from the upper basket. 3. Close the water tap. • For better drying results, keep the appliance door ajar There can be water on the sides and on the door of for some minutes. - Page 10 First try to find a solution to the problem (refer to the ta- With some problems, some indicators flash continuously ble). If not, contact the Service. and/or intermittently at the same time to show an alarm code. Alarm code Problem •...
- Page 11 If the problem occurs again, contact the Service. If other alarm codes show, contact the Service. The washing results and drying results are not satisfactory Problem Possible cause Possible solution The dishes are not clean. The filters are clogged. Clean the filters. The filters are not correctly assembled Make sure that the filters are correctly as- and installed.
-
Page 12: Technical Information
Problem Possible cause Possible solution The dishes are wet and matt. The rinse aid dispenser is empty. Make sure that there is rinse aid in the rinse aid dispenser. The quality of the rinse aid can be the Try a different brand of rinse aid. cause. - Page 16 www.zanussi.com/shop...