Zanussi ZDI11004XA User Manual page 18

Adjusting the water softener
German
degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
Electronic adjustment
1. Press the on/off button to activate the ap-
pliance. The on/off indicator comes on.
Make sure that the appliance is in setting
mode. Refer to 'SETTING AND STARTING
A PROGRAMME'.
2. Press and hold function buttons (B) and
(C) at the same time until the indicators of
function buttons (A), (B) and (C) flash.
3. Press function button (A).
• The indicators of function buttons (B)
and (C) go off.
• The indicator of function button (A) con-
tinues to flash.
• The end indicator flashes showing the
setting of the water softener.
– The number of flashes of the end indi-
cator shows the level of the water
softener.
Example: 5 flashes + pause + 5 flash-
es = level 5.
4. Press function button (A) again and again
to change the setting. Each time you press
function button (A) you go to the next level.
18
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
www.preciz.hu
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
5. Deactivate the appliance to confirm.
Filling the salt container
Caution! Water and salt can come out
from the salt container when you fill it.
Risk of corrosion. To prevent it, after you fill
the salt container, start a programme.
1
Water softener
adjustment
Level
10
9
8
7
6
1)
5
4
3
2
2)
1
2
www.zanussi.com