Hints And Tips - Zanussi ZDI11004XA User Manual

• The phase indicators of the set pro-
gramme come on.
6. Close the appliance door. The programme
starts.
• The indicator of the phase in operation is
on.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again un-
til the indicator of the number of hours you
want to set flashes. You can set 3, 6 or 9
hours.
3. Close the appliance door. The countdown
starts.
• The delay indicator stops flashing.
• The phase indicators of the set pro-
gramme go off.
• When the countdown is completed, the pro-
gramme starts.
– The indicator of the phase in operation
comes on.
– The delay indicator goes off.
You can set a programme and the delay
start also with the appliance door closed.
In this condition, you have only 3 seconds after
each setting before the appliance starts to op-
erate.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance con-
tinues from the point of interruption.

Hints and tips

The water softener
Hard water contains a high quantity of miner-
als that can cause damage to the appliance
and bad washing results. The water softener
neutralises these minerals.
The dishwasher salt keeps the water softener
clean and in good conditions. It is important to
set the right level of the water softener. This
makes sure that the water softener uses the
correct quantity of dishwasher salt and water.
www.zanussi.com
www.preciz.hu
Cancelling the delay start
Press and hold function buttons (B) and (C) at
the same time until the delay indicator goes off
and all the programme indicators come on.
When you cancel a delay start, the appli-
ance goes back to setting mode. You
have to set the programme again.
Cancelling the programme
Press and hold function buttons (B) and (C) at
the same time until all the programme indica-
tors come on.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed, the end
indicator comes on.
1. Press the on/off button to deactivate the
appliance. The on/off indicator goes off.
2. Close the water tap.
• Let the dishes become cold before you
remove them from the appliance. Hot
dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.
• There can be water on the sides and
on the door of the appliance. Stainless
steel becomes cool more quickly than
the dishes.
Using salt, rinse aid and detergent
• Only use salt, rinse aid and detergent for
dishwasher. Other products can cause
damage to the appliance.
• The rinse aid helps, during the last rinsing
phase, to dry the dishes without streaks and
stains.
• Combi detergent tablets contain detergent,
rinse aid and other added agents. Be sure
that these tablets are applicable to the wa-
21