York Taurus Series Installation And Operation Instructions Manual page 5

f The Cabinet should be secured to the Wooden Frame In order to prevent the Unit from falling
down. Holes are provided on the Left, Right & Bottom sides of the Cabinet (See Fig. - G) for fixing it
to the Wooden Frame. Choose a side of the Wooden Frame which is right angle to the bottom
surface to fix the Cabinet and use Nails or Screws (Not supplied) for fixing it. If required, provide two
Brackets (Not supplied) on the rear side to support the Unit.
g If required, fix an Ornamental Frame (Not supplied) around the Cabinet on the Room side to cover
the Gaps between the Cabinet and the Wooden Frame as shown in Fig. - H.
h Fix the Drain tube to the Rectangular opening provided on the Lower left portion on the rear side of
the Unit. The orientation of the Drain Tube should be as shown In Fig. - I to maintain sufficient
Condensed water level in the Base Tray for splashing Water on the Condenser Coil.
i Push the Unit completely back into the Cabinet fitted in the Window.
j Weather seal the openings on the Front Bottom portion (Between the Cabinet inner surface and
the unit) with the Urethane Foam provided with the unit. (See Fig. - J)
k Fix the Front Panel to the Cabinet by hooking the two Stoppers provided on the Top under side of
the Front Panel to the Rectangular slots provided on the Top side of the Cabinet (See Fig. - J), Flush
fit the Front Panel to the Cabinet and fix one each Screw (Supplied) from both sides of the Front
Panel to Cabinet.
l Complete the installation by connecting the Power Supply Cord. Ensure that all wire connections
are tightend & secure
No. Description
1 Wall
2 Wooden Frame
3 Cabinet
4 Bracket, Cabinet Support (2 pcs.)
5 Urethane Foam (Cabinet outside)
6 Ornamental Frame
7 Drain Tube
8 Plastic Front Panel
8a Return Air Grille Insert
8b Horizontal Deflectors (Hori. Louvers)
8c Air Filter
Fig. - F
No. Description
8d Cover - Control Panel
8e Air Filter - Special
9 Unit
10 Urethane Foam (Front Bottom)
11 Control Panel
12 Indicator Light
13 Air Swing switch (Vertical Air deflector)
14 Knob - Operation / Mode Switch
15 Knob - Temperature Setting Thermostat
16 Vertical Air Deflector (Vert. Louver)
17a Exhaust Damper Lever (Front)
17b Exhaust Damper Lever (Top)
Holes for fixing
Nails or Screws
Fig. - G
4