York Taurus Series Installation And Operation Instructions Manual page 12

C. FAN BUTTON
- By pressing this button each time the fan speed will change in the following sequence.
- This will be indicated by the LED lights on the Control Panel Key Pad.
-
There is no AUTO fan speed available in FAN mode.
D. SWING BUTTON
- Press this button to run on swing mode.
- Press it again to stop the louver in the preferred air distribution location.
E. TEMPERATURE UP & DOWN BUTTONS
- Each Press of these button will increase or decrease the set temperature by 1°C.
- The range of set temperature is 16°C - 30°C.
- Temperature setting is disabled in FAN mode.
F TIMER BUTTON
- ON Timer can only be set when the system is OFF.
- OFF Timer can only be set when system is ON.
- Pressing of 'ON' or 'OFF' button will display the previous timer.
- Press UP or DOWN button to set the desired new timer.
- The range of timer is 0-24 hours.
- After time mode is set, TIMER LED light will be ON.
- Air conditioning until will turn ON or OFF automatically when the set number of hour have elapsed.
- Changing of ON/OFF state will cancel TIMER mode.
- Timer will cancel during power failure.
G 7. SEGMENT DISPLAY
- This display will show Room temperature during normal working.
- This display will show Set temperature when setting the temperature.
- This display will show Timer when setting the Timer.
- The following are various error diagnostic indications displayed on the 7 segment display.
Room temperature sensor failure
Indoor Coil Sensor Failure
Outdoor coil sensor failure (For Heat pump)
Compressor / 4WV failure (For Heat pump)
H OPERATION MODE DISPLAY
- Shows the selected operation mode Cool, Fan Or *Heat.
- Following are the other indications available for the protections.
Indoor coil frost prevention
Outdoor auto defrost (For Heat pump)
Š
LOW MED
FAULT CONDITION
PROTECTIONS
HIGH AUTO LOW
INDICATION
E1 on Display
E2 on Display
E3 on Display
E4 on Display
INDICATION
COOL LED blinks continuously
HEAT LED blinks continuously
11