Control Removal (Electronic); Control Panel (Mechanical) - Amana ALD10DT P1331001M Service Manual

Disassembly Procedures
Control Panel (Electronic)
1. Disconnect power to oven.
2. Remove outer case, see "Outer Case" procedure.
2. Disconnect and label wires from control board.
3. Open oven door.
4. Remove screw securing control panel to cavity. Lift
control panel up and out to release tabs.
5. Remove screws securing control board to control
panel.
6. Replace component and reverse procedure to
reassemble.

Control Panel (Mechanical)

1. Disconnect power to oven.
2. Remove outer case, see "Outer Case" procedure.
2. Disconnect and label wires from control.
3. Open oven door.
4. Remove screw securing control panel to cavity. Lift
control panel up and out to release tabs.
5. Remove timer knob from timer.
6. Remove screws securing timer to control panel and
©2009 ACP Inc.
To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.
7. Remove timer couple from timer.
8. Remove screw securing knob coupler and flat spring
from control panel.
9. Replace component and reverse procedure to
reassemble.
Control Panel (Electronic Dial)
1. Disconnect power to oven.
2. Remove outer case, see "Outer Case" procedure.
2. Disconnect and label wires from control board.
3. Open oven door.
4. Remove screw securing control panel to cavity. Lift
control panel up and out to release tabs.
5. Remove eight screws which secure the control panel.
6. Remove control panel.
7. Replace component and reverse procedure to
reassemble.
Knob
16400005
LED
Control
Holder PCB
Panel
Screws
29