Connecting The Ac Power Cord - Sony LMD-1530MD Instructions For Use Manual

AUDIO IN/OUT (phono jack)
When using an analog RGB or a component signal
as a video signal, use these jacks for the input/output
of an audio signal. Connect them to the audio input/
output jacks on equipment such as a VCR.
g PARALLEL REMOTE connector (modular
connector, 8-pin)
Forms a parallel switch and controls the monitor
externally.
When the unit is shipped from the factory, a connector
cover is attached to this connector. Remove it before
using the connector.
For removing the connector cover, see page 16.
For details on the pin assignment and factory setting
function assigned to each pin, see page 26.
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
h LINE connectors
Line input connectors for Y/C separate, composite video
and audio signals and their loop-through output
connectors.
Press the LINE button to monitor the signal input
through these connectors.
If you input signals to both Y/C IN and VIDEO IN, the
signal input to the Y/C IN is selected.
Y/C IN/OUT (4-pin mini-DIN)
These are the input/output connectors for a Y/C
separate signal. Connect them to the Y/C separate
input/output connectors on equipment such as a
VCR, video camera, or another monitor.
VIDEO IN/OUT (BNC)
These are the input/output connectors for a
composite video signal. Connect them to the
composite video input/output connectors on
equipment such as a VCR, video camera, or another
monitor.
AUDIO IN/OUT (phono jack)
These are the input/output jacks for an audio signal.
Connect them to the audio input/output jacks on
equipment such as a VCR.
i
/I (Equipotential/Function Earth) terminal
(equipotential) terminal
Connects the equipotential plug.
I (function earth) terminal
Connects the earth cable.
j AC IN socket
Connect the supplied AC power cord.
Connecting the AC
Power Cord
1
Plug the AC power cord into the AC IN socket on
the rear panel. Then, attach the AC plug holder
(supplied) to the AC power cord.
AC IN socket
AC plug holder
(Supplied)
2
Slide the AC plug holder over the cord until it
locks.
To disconnect the AC power cord
Pull out the AC plug holder while pressing the lock
levers.
AC power cord

Connecting the AC Power Cord

15