Features - Sony LMD-1530MD Instructions For Use Manual

Features

The LMD-1530MD is a 15.3-type LCD monitor that
conforms to medical safety standards. This unit is
suitable for endoscopy or use as a sub-monitor.
Compliance with medical safety standards in
U.S.A., Canada and Europe
IEC 60601-1 and product safety standards in the U.S.A.,
Canada and Europe have been obtained for this monitor.
The monitor is designed for use in the medical treatment
field, with screen protect panel, etc.
High brightness LCD panel
Because of the monitor's high brightness, high contrast
and wide viewing angle technology, it can be used under
various lighting conditions.
Monitor stand with tilt function
As the stand with tilt function is equipped normally for
the monitor, you can use it easily on the desk top.
Tally lamp
The green LED lamp is used for the tally lamp. You can
check the status of the monitor, controlling the lamp
from the external remote.
Multi-format
The monitor supports the video, Y/C, RGB, component
1)
and HDMI input signals.
Both NTSC and PAL color systems are supported, and
the appropriate color system is selected automatically.
HD/SD-SDI signals can be available when input adaptor
BKM-341HS (optional) is used.
For more information, see "Video signal formats"
(page 27).
1)
HDMI, the HDMI logo and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LLC.
Blue only mode
In the blue only mode, an apparent monochrome display
is obtained with all three of the R/G/B cathodes driven
with a blue signal. This facilitates color saturation and
phase adjustments and observation of signal noise.
Analog RGB/component input connectors
Analog RGB or component signals from video
equipment can be input through these connectors.
Y/C input connectors
Y/C signals of the video signal can be input through this
connector.
External sync input
When the EXT SYNC button is in the on position, the
unit can be operated on the sync signal supplied from an
external sync generator.
Automatic termination (connector with
mark only)
The input connector is terminated internally at 75 ohms
when nothing has been connected to the output
connector. If a cable is connected to the output
connector, the internal terminal is automatically released
and the signals input to the input connector are output to
the output connector (loop-through).
Select color temperature and gamma mode
You can select the color temperature from among three
(HIGH, LOW and LOW2) settings and gamma mode
from among five settings. You can also adjust the color
temperature to the appropriate setting.
Aspect setting
You can set the monitor to 4:3 or 16:9 display mode
according to the input video signal.
Scan setting
You can set the display size to normal scan, over scan or
full screen.
Key inhibit function
You can inhibit a key function to prevent misoperation.
Select language display
You can select from seven display languages English,
Chinese, Japanese, Italian, Spanish, German and
French.
External remote control function
You can directly select the input signal, aspect, etc., by
operating the equipment connected to the PARALLEL
REMOTE terminal.
I/P mode setting
This unit is equipped with an I/P mode setting function
that is used to minimize picture delay due to the signal
conversion process.
Two kinds of ground terminals
Two kinds of ground terminals are built into the monitor
to equal the electric potential.
11
Features