Itime Programmer Controls And Display - IDEAL ESPRIT 2 24 User Manual

"Heating"
Press this
button to cycle
from 'TIMED' to
'ADVANCE' then
'ON' and 'OFF'.
'ADVANCE'
indicates an
early change to
the next program
selection. 'ON
and OFF' are
'indefinite'
i.e. the boiler
will remain so.
The 'Prog' button is used to change
into Programming mode, in order to
check programs and to reset the clock.
(See Frame 2 to 9)
NB - The Prog button also
functions in program mode as a
back key and an abort key (press
and hold).
These symbols relate to the times being programmed
1, 2 and 3 are the daily periods. ON and OFF are the
functions. DEL is used to clear a programmed period.
ON
OFF
TIMED
ADVANCE
PROG
'PROG' is shown during
program amendment
"Heating demand" also
shown during programming
"Hot Water demand" also
shown during programming
This symbol is shown when
the clock is being set
ITIME PROGRAMMER - CONTROLS AND DISPLAY
MON TUE
ON 1 2 3
OFF ON
TIMED OFF
ADVANCE DEL
PROG
prog prog select select
The 'Select' button is normally
used to make choices within menus.
It selects whichever option on the
display is flashing.
NB - The Select button also
functions as a Reset button for
fault conditions. (See Frame 7)
MON TUE WED
1 2 3
ON
OFF
DEL
WED THU FRI SAT
time
+
P R O G R A M M E R
THU FRI SAT
o C
AM
PM
+1hr
"Hot Water"
SUN
o C ON
AM OFF
PM TIMED
+1hr ADVANCE
-
The 'Up' and 'Down' buttons
are used to amend values
and move around within menus.
NB - The 'Up' button also makes
the change to and from Summer-
time. For this function, press for 3
seconds.
ON, OFF, TIMED, ADVANCE
indicate the current selected
mode for each channel.
In TIMED mode, ON will be
shown within a timed ON period.
SUN
ADVANCE is shown when the
ON
channel is moved on to the next
OFF
programmed event. Once the
TIMED
event has finished ADVANCE
ADVANCE
will no longer be shown.
"Summertime" indicator -
To set or reset this,
press the 'UP' button and
hold for 3 seconds.
A steady 'flame' symbol
indicates that the boiler is on.
If flashing, the boiler is active,
but not firing at the time.
The 'spanner' symbol is shown
when an engineer may be needed
(See Frame 7)
Press this
button to cycle
from 'TIMED' to
'ADVANCE' then
'ON' and 'OFF'.
'ADVANCE'
indicates an
early change to
the next program
selection. 'ON
and OFF' are
'indefinite'
i.e. the boiler
will remain so.