Rear Wheel Drive Solenoid Replacement - Toro Reelmaster
4000?D Service Manual

Rear Wheel Drive Solenoid Replacement

RM 4000−D 4WD
MANIFOLD BLOCK
Figure 28
1. Disconnect solenoid electrical connector.
2. Remove nut from solenoid.
3. Remove solenoid coil.
4. Install new solenoid coil. Make sure o−ring is
installed at each end of coil. Apply "Loctite 242" or equiv-
alent to threads on end of valve stem before installing
nut. Tighten nut to a torque of 15 in−lb (17.3 kg−cm).
Over−tightening may damage the solenoid or cause the
valve to malfunction.
5. Connect wiring connector.
Figure 29
Reelmaster 4000−D Page 5 − 35 Electrical System (Rev. C)