Page 2
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR FUTABA Transmitter Ready, abbreviated to FTR, applies to selected models from the Nine Eagles range. These models' transmitter and receiver work with the FUTABA S-FHSS code, which means that they can also be control- led by FUTABA transmitters which can be operated in S-FHSS mode.
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Do not stand close to the hazard area around rotating parts when Be sure to read these Safety Notes before you assemble your mo- del. Always keep to the procedures and settings recommended in an electric motor is connected to the flight battery.
Page 5
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Use only those components and accessories which we specifically re- Liability Exclusion commend. robbe Modellsport is unable to ensure that you observe the assembly and operating instructions, or the conditions and methods used for installing, Do not carry out modifications to the radio control system components operating and maintaining the model components.
Page 6
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Dear customer, Congratulations on choosing a model aircraft from our ran- ge. Many thanks for placing your trust in us. The model can be completed and made ready to fly very quickly.
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Assembling the model Insert the joiner rod in the ope- Engage the propeller in the ning in the left-hand wing panel driver disc on the motor shaft (Fig.1). (Fig.4).
Page 8
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Using the charger to charge the flight battery Safety Notes regarding LiPo batteries: • Do not place the battery in water or any other liquid. • Do not heat or incinerate the battery; do not place it in a microwave oven. • Avoid short-circuits, and never charge the battery with reversed polarity • Do not subject the battery to pressure or shock loads, and never distort or throw the pack.
Page 9
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Transmitter settings, Mode 1: Transmitter settings, Mode 2 (as supplied): Elevator trim Throttle trim Elevator trim Throttle trim Rudder Rudder Elevator Speed Speed Elevator control control control control Rudder...
Page 10
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR "Primary" and "expanded" control function setting Converting the transmitter from "Mode 2" (throttle left) to "Mode 1" (throttle right) The transmitter offers the facility to adjust the sensitivity of the stick movements. We recommend "softer" reduced The transmitter is supplied set to Mode 2 as standard.
Page 11
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Transmitter settings Mode 1 Throttle trim: If the propeller starts to move without you touching the throttle stick, or does not respond to stick movements, cor- rect this with the throttle trim.
Page 12
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Transmitter settings Mode 2 Throttle trim: If the propeller starts to move without you touching the throttle stick, or does not respond to stick movements, cor- rect this with the throttle trim.
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Flight preparation The correct pre-flight procedure. Open the transmitter battery compartment and insert the four AA cells* (check for correct polarity). Switch the transmitter on (Fig. 1). The battery status is displayed on the right-hand side of the screen.
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Controlling the model in Mode 1 Controlling the model in Mode 2 High RPM (launch): Motor off (landing): High RPM (launch): Motor off (landing): Left turn: Right turn: Left turn:...
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Important Notes The first few flights Once the model is properly trimmed, you can practise the Launching: art of flying, and carry out manoeuvres such as circles, Hold the aeroplane in your hand, set the motor to full power, and squares, rectangles and figures-of-eight.
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Re-binding the transmitter This procedure is only necessary if you replace individual components, or if you wish to bind a FUTABA transmitter (please also read the point "Binding the receiver" in the operating instructions supplied with your FUTABA transmitter).
Replacement parts list - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR Replacement parts list - SKY RUNNER RTF Order No. Description NE200704 Propeller set NE200706 Control surface linkage NE200707 Motor set NE200708 Receiver NE200709 Wing NE200704 NE200706 NE200707 NE200710...
Page 19
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR robbe Modellsport GmbH & Co. KG hereby declares that this device conforms to the fundamental requirements and other relevant regulations of the corresponding EC Directive. Under www.robbe.com, you will find the original Conformity Declaration by clicking on the Logo button "Conform"...
Page 20
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR robbe Modellsport GmbH & Co.KG robbe Modellsport GmbH & Co.KG Metzloserstraße 38 · D-36355 Grebenhain Technical hotline: +49 (0)66 44 / 87-777 · hotline@robbe.com Commercial register: Gießen Regional Court HRA 2722 Partner with personal liability: robbe Modellsport Beteiligungs GmbH Gießen / HRB 5793 Managing Director: E.
Need help?
Do you have a question about the SKY RUNNER RTF and is the answer not in the manual?
Questions and answers