Operating Instructions SOLO PRO 229 EC145 Black SOLO PRO 229 EC145 Police FTR RTB FTR RTB 2.4 GHz 2.4 GHz No. NE3525RTB No. NE3524RTB...
Page 2
FUTABA Transmitter Ready, abbreviated to FTR, applies to selected models from the Nine Eagles range. These models' transmitter and receiver work with the FUTABA S-FHSS code, which means that they can also be controlled by FUTABA transmitters which can be operated in S-FHSS mode.
Page 3
Operating Instructions - SOLO PRO 229 EC145 Police FTR RTB 2.4 GHz No. NE3524RTB SOLO PRO 229 EC145 Black FTR RTB 2.4 GHz No. NE3525RTB Explanation of specialist terms: Contents Page Explanation: FTR system Climb and descent ("Throttle / pitch"): This controls Explanation of specialist terms / Contents the model's climb and descent.
Page 4
Be sure to read these Safety Notes before you fly your mo- Do not stand close to the hazard area around rotating del. Always keep to the procedures and settings recommen- parts when an electric motor is connected to the flight ded in the instructions.
Page 5
Operating Instructions - SOLO PRO 229 EC145 Police FTR RTB 2.4 GHz No. NE3524RTB SOLO PRO 229 EC145 Black FTR RTB 2.4 GHz No. NE3525RTB Operating the model Insurance Caution - injury hazard: Ground-based models are usually covered by standard personal Please keep your model helicopter a safe distance away third-party insurance policies.
Page 6
Dear Customer, Congratulations on choosing a factory-assembled mo- del helicopter from our range. Many thanks for placing your trust in us. The model can be completed and prepared for flight very quickly. Please read right through these instruc- tions before attempting to fly the model for the first time, as this will make it much easier to operate the model safely.
Page 7
Operating Instructions - SOLO PRO 229 EC145 Police FTR RTB 2.4 GHz No. NE3524RTB SOLO PRO 229 EC145 Black FTR RTB 2.4 GHz No. NE3525RTB Safety Notes regarding LiPo batteries: • Do not place the battery in water or any other liquid. • Never heat or incinerate the pack, or place it in a microwave oven. • Avoid short-circuits, and never charge the battery with reversed polarity • Do not subject the battery to pressure or shock loads, and never distort or throw the pack • Never solder directly to the battery • Do not modify or open the battery...
Page 8
Charging the flight battery Model description: 1. Triple-axis gyro system, ensuring stable, accurate flight. Connect battery 2. The high-performance brushless motor provides ample power charger to the mains for advanced 3D flying. PSU, and plug the PSU 3. FUTABA S-FHSS receiving system for binding to all current into a mains socket.
Page 9
Operating Instructions - SOLO PRO 229 EC145 Police FTR RTB 2.4 GHz No. NE3524RTB SOLO PRO 229 EC145 Black FTR RTB 2.4 GHz No. NE3525RTB Collective pitch and throttle settings Overview of rotor control system (Recommended transmitter programming) Normal flight...
Page 10
Preparing the transmitter, using the Futaba T8J as an example: - Set S-FHSS modulation - The transmitter must be set to swashplate mode H-1 (see T8J instructions, 8.1 Parameter, page 38) Please note: 1. The model must stand on a level surface during the initialisation process. 2.
Page 11
Operating Instructions - SOLO PRO 229 EC145 Police FTR RTB 2.4 GHz No. NE3524RTB SOLO PRO 229 EC145 Black FTR RTB 2.4 GHz No. NE3525RTB Binding the transmitter to the model: - Switch the transmitter on, then connect the flight battery.
Page 12
These points must be checked before flying: Controlling the model Mode 1 Mode 2 Roll: - Before flying the model check that the receiver battery is If you move the roll fully charged, and that the transmitter batteries still have stick to left or right, adequate capacity.
Page 13
Operating Instructions - SOLO PRO 229 EC145 Police FTR RTB 2.4 GHz No. NE3524RTB SOLO PRO 229 EC145 Black FTR RTB 2.4 GHz No. NE3525RTB Important Notes The first few flights Take-off: raise the rotor speed slowly and steadily until the mo- Ideally the first flight should take place in a large indoor space del hovers at eye-level.
Page 15
Operating Instructions - SOLO PRO 229 EC145 Police FTR RTB 2.4 GHz No. NE3524RTB SOLO PRO 229 EC145 Black FTR RTB 2.4 GHz No. NE3525RTB Replacement Parts list - SOLO PRO 229 EC145 Police FTR RTB Replacement Parts list - SOLO PRO 229 EC145 Black FTR RTB Order No.
Page 16
robbe Modellsport GmbH & Co. KG hereby declares that this device conforms to the fundamental requirements and other relevant regulations of the corresponding EC Directive. You can read the original Conformity Declaration on the Internet at www.robbe.com: click on the "Confor- mity Declaration" logo button which you will find next to the corresponding device description. This symbol means that you should dispose of electrical and electronic equipment separately from the household waste when it reaches the end of its useful life.
Need help?
Do you have a question about the SOLO PRO 229 EC145 Police and is the answer not in the manual?
Questions and answers