Advertisement
Quick Links
Advertisement
Related Manuals for Nine Eagles SKY SURFER RTF FTR
Summary of Contents for Nine Eagles SKY SURFER RTF FTR
-
Page 1: Operating Instructions
Operating Instructions SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR... - Page 2 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR FUTABA Transmitter Ready, abbreviated to FTR, applies to selected models from the Nine Eagles range. These models' transmitter and receiver work with the FUTABA S-FHSS code, which means that they can also be control- led using FUTABA transmitters which can be operated in S-FHSS mode.
- Page 3 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Explanation of specialist terms: Contents Page FTR system Motor speed ("Throttle"): This controls the rotati- Explanation of specialist terms / Contents onal speed of the motor. Stick forward = maximum...
- Page 4 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Do not stand close to the hazard area around rotating parts when Be sure to read these Safety Notes before you assemble your mo- del. Always keep to the procedures and settings recommended in an electric motor is connected to the flight battery.
- Page 5 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR to failure in subsequent use. Insurance Use only those components and accessories which we specifically re- Ground-based models are usually covered by standard personal third- commend. party insurance policies. In order to fly model aircraft you will need to extend the cover of your existing policy, or take out specific insurance.
- Page 6 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Dear customer, Congratulations on choosing a model aircraft from our ran- ge. Many thanks for placing your trust in us. The model can be completed and made ready to fly very quickly.
- Page 7 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Assembling the model Connect the aileron servo lead (white plug) to the receiver lead (white socket) (Fig. 1). Fig. 1 Place the wing on the fuselage, and set it at right-angles to the fuselage centreline.
- Page 8 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Using the charger to charge the flight battery Safety Notes regarding LiPo batteries: • Do not place the battery in water or any other liquid. • Do not heat or incinerate the battery; do not place it in a microwave oven. • Avoid short-circuits, and never charge the battery with reversed polarity • Do not subject the battery to pressure or shock loads, and never distort or throw the pack.
- Page 9 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Transmitter settings, Mode 1: Transmitter settings, Mode 2 (as supplied): Elevator trim Throttle trim Elevator trim Throttle trim Elevator Aileron Speed Elevator Rudder Speed Rudder Aileron control control control...
- Page 10 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR "Primary" and "expanded" control function setting Converting the transmitter from "Mode 2" (throttle left) to "Mode 1" (throttle right) The transmitter offers the facility to adjust the sensitivity of the stick movements. We recommend "softer" reduced The transmitter is supplied set to Mode 2 as standard.
- Page 11 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Transmitter settings Mode 1 Throttle trim: If the propeller starts to move without you touching the throttle stick, or does not respond to stick movements, cor- rect this with the throttle trim.
- Page 12 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Transmitter settings Mode 2 Throttle trim: If the propeller starts to move without you touching the throttle stick, or does not respond to stick movements, cor- rect this with the throttle trim.
- Page 13 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Flight preparation The correct pre-flight procedure. Open the transmitter battery compartment and insert the four AA cells* (check for correct polarity). Switch the transmitter on (Fig. 1). The battery status is shown on the right of the screen.
- Page 14 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Controlling the model in Mode 1 Controlling the model in Mode 2 High RPM (launch): Motor off (landing): High RPM (launch): Motor off (landing): Left turn: Right turn: Left turn:...
- Page 15 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Important Notes The first few flights Once the model is properly trimmed, you can practise the Launching: art of flying, and carry out manoeuvres such as circles, Hold the aeroplane in your hand, set the motor to full power, and squares, rectangles and figures-of-eight.
- Page 16 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Re-binding the transmitter This procedure is only necessary if you replace individual components, or if you wish to bind a FUTABA transmitter (please also read the point "Binding the receiver" in the operating instructions supplied with your FUTABA transmitter).
- Page 17 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Replacement parts list - SKY SURFER RTF FTR Order No. Description NE200004 Control surface linkage NE200005 Propeller set NE200006 Motor set NE200007 LiPo battery, 7.4 V / 250 mAh...
- Page 18 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR Notes:...
- Page 19 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR robbe Modellsport GmbH & Co. KG hereby declares that this device conforms to the fundamental requirements and other relevant regulations of the corresponding EC Directive. Under www.robbe.com, you will find the original Conformity Declaration by clicking on the Logo button "Conform"...
- Page 20 Operating instructions - SKY SURFER RTF FTR 2.4 GHz No. NE2000FTR robbe Modellsport GmbH & Co.KG Metzloserstraße 38 · D-36355 Grebenhain Technical hotline: +49 (0)66 44 / 87-777 · hotline@robbe.com Commercial register: Gießen Regional Court HRA 2722 Partner with personal liability: robbe Modellsport Beteiligungs GmbH Gießen / HRB 5793 Managing Director: E.