Re-Binding The Transmitter - Nine Eagles SKY RUNNER RTF Operating Instructions Manual

Re-binding the transmitter

This procedure is only necessary if you replace individual components, or if you wish to bind a FUTABA transmitter (please
also read the point "Binding the receiver" in the operating instructions supplied with your FUTABA transmitter).
1. Switch the transmitter on (Fig. 1) and connect the flight battery (Fig. 2). Ensure that the distance between the transmitter
and the model is not greater than 25 cm.
2. The green monitor LED on the receiver circuit board glows constantly. Locate the Bind button on the receiver (Fig. 3) and
hold it pressed in for about three seconds. Release the Bind button, and the model is now bound to the transmitter. This
process may take several seconds. Do not move the model or the transmitter sticks during the binding process.
3. The green monitor LED continues to glow during the binding process. When the procedure is complete, the red monitor
LED on the receiver glows constantly. The model can now be operated.
(Fig. 1)
16
Operating instructions - SKY RUNNER RTF FTR 2.4 GHz No. NE2007FTR
(Fig. 2) (Fig. 3)