Kobalt KPS 80-06 User Manual page 18

CARE AND MAINTENANCE
Chain oiler
WARNING
To avoid possible serious injury, stop the motor and
remove the battery from the pole saw before replacing the
bar, chain, or performing any maintenance operation.
•
Use Premium Bar and Chain Lubricant. It is designed
for chains and chain oilers and is formulated to
perform over a wide temperature range with no dilution
required.
•
Remove the cap and carefully pour approximately
2 oz (57 g) of bar and chain lubricant into the bar lube
reservoir.
•
Replace the cap and tighten securely.
•
pole saw is used.
Note:
•
Do not use dirty, used, or otherwise contaminated
lubricants. Damage may occur to the oil pump, bar,
or chain.
Bar Lube Reservoir
kobalttools.com
18
F