Kobalt KPS 80-06 User Manual page 10

OPERATING INSTRUCTIONS
Battery
IMPORTANT: The battery may not be charged when
time, place the battery in the battery charger and charge.
Make sure to read all safety precautions and follow the
instructions in the battery and charger manuals.
To install the battery:
1. Align the battery (not included) with the battery opening.
2. Insert the battery into the battery opening until the
battery release button (I) locks into place.
3. Push down on the battery until it locks into place. You
should hear a "click" once it is installed.
To remove the battery:
1. Press the battery release button (I) on the pole saw.
This will cause the battery to slightly raise out of the
tool.
2.
the handle.
WARNING
•
Replace the battery or the charger immediately if the battery case or charger cord is
damaged.
•
Verify that the switch is in the OFF position before inserting or removing the battery pack.
•
Verify that the battery is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the pole saw.
•
Read, understand, and follow the instructions contained in the charger manual.
IMPORTANT
This lithium-ion battery is equipped with an internal circuit breaker which will automatically shut off
the power to the tool and then reset itself once cooled. Follow these steps if an overload occurs while
under heavy use:
1. Release the power switch and restart tool by depressing switch.
2. The battery may need to be removed for approximately 1 minute, allowed to cool and then
reinstalled for use.
kobalttools.com
10
I