Data Storage - GO SwissDrive EVO Original Instruction Manual

Subsequently, a list symbol (1)
indicating that a new call or a new SMS was registered in the phone menu. In the list
the calls and SMS are sorted by date and time whereas the latest call or the latest
SMS are indicated at the top. If the number of the incoming call or incoming SMS is
recorded in the phone book of your mobile phone, the name recorded in your mobile
phone instead of the phone number is indicated in the list.
You can delete the list of incoming calls and SMS by navigating with the +/–keys of
the handlebar remote to the "Delete list" button and by pressing the Confirm key.
For road-safety reasons you should always stop before using your
G
mobile phone.
Keep in mind that only the list recorded in your Evo control unit is
I
deleted. The information in your mobile phone is neither changed nor
deleted by that.
The phone menu of your Evo control unit is a pure visualisation of the
I
data of your mobile phone. You cannot answer or make any calls with
the Evo control unit.
26

11. DATA STORAGE

„
Your Evo control unit offers you the option to save your current tour data and your
total data via the USB interface or the Bluetooth interface on an external device.
To ensure a trouble-free function the external storage device (e.g. USB
i
stick) must be formatted to FAT32.
1
is displayed with the phone symbol in the status bar
2
If an external device is connected with the Evo control unit via one of these two inter-
faces, you can select one of four storage variants in the menu "Data storage"
navigating with the +/–keys of the handlebar remote to the desired button and start
the saving process by pressing the Confirm key. The currently marked button is high-
lighted green. The successful storage of the data on the external device is confirmed
by the display with a pop-up (3).
12. SERVICE MENU
„
In the event of an error of the GO SwissDrive system, the service menu
compact instructions to fix this error.
There is a list with the latest errors occurred. Each error indicator consists of a letter
and a two-digit number. With the letter the component concerned by the error can be
identified.
- M: motor error
- D: display error
- B: battery error
- C: communication error
In case of a communication error the communication between the individual system
components is disturbed. Even if the components themselves still work trouble-free,
the system changes into the error mode for safety reasons. It often suffices to check
the cables and the connectors to remedy the communication problems.
3
GO SWISSDRIVE
(2) by
(4) offers you
4
27