Table of Contents
Advertisement
Hardware Interface
5.1 GigE Connector
The GigE cameras are interfaced to external components via
•
an Ethernet jack (RJ45) to transmit configuration, image data and trigger.
•
a 12 pin subminiature connector for the power supply, Hirose HR10A-10P-12S (female) .
The connectors are located on the back of the camera. Fig. 5.1 shows the plugs and the status
LED which indicates camera operation.
S t a t u s L E D
Figure 5.1: Rear view of the GigE camera
5.2 Power Supply Connector
The camera requires a single voltage input (see Table 3.4). The camera meets all performance
specifications using standard switching power supplies, although well-regulated linear power
supplies provide optimum performance.
It is extremely important that you apply the appropriate voltages to your camera.
Incorrect voltages will damage the camera.
- t h e r n e t J a c k ( R J 4 5 )
5
P o w e r S u p p l y
a n d I / O
C o n n e c t o r
71
Advertisement
Table of Contents
