Photon Focus MV1-D1024E User Manual page 21

Gigabit ethernet series cmos area scan cameras

Hide thumbs Also See for MV1-D1024E:

Table of Contents

If no images can be grabbed, close the PF_GEVPlayer and adjust the Jumbo

Frame parameter (see Section 2.3) to a lower value and try again.

Figure 2.14: PF_GEVPlayer displaying live image stream

Check the status LED on the rear of the camera.

The status LED light is green when an image is being acquired, and it is red when

serial communication is active.

Camera parameters can be modiﬁed by clicking on GEV Device control (see Fig. 2.15). The

visibility option Beginner shows most the basic parameters and hides the more advanced

parameters. If you don't have previous experience with Photonfocus GigE cameras, it is

recommended to use Beginner level.

Figure 2.15: Control settings on the camera

2.6 Getting started

Table of Contents