EGO LM2000-S Operator's Manual page 16

ATTACHING/REMOVING THE GRASS BAG
WARNING: Do not at any time make any adjustment to the
lawn mower without first stopping the motor and removing the
safety key.
NOTICE: Remove the mulching insert or side discharge chute
before attaching the grass bag on the mower;
1. Adjust the handle to the Grass Bag Attachment/Removal
Position (please see ADJUSTING THE FOLDABLE HANDLE).
2. Lift the rear discharge door.
3. Hook the grass bag assembly on the pivot rod
(Fig. 9). Release the discharge door so that it rests on the
grass bag.
4. To remove the grass bag, lift the rear discharge door on the
mower. Lift the grass bag up, off of the pivot rod.
5. Release the discharge door.
WARNING: When using the grass bag, never operate the mower unless the hooks on the grass bag are firmly seated
on the pivot rod and the rear discharge door rests firmly against the top of the grass bag.
NOTICE: Under normal usage, bag material is subject to wear. To reduce the risk of injury, frequently inspect the bag
assembly and replace if there are any signs of wear or deterioration. Use only grass bags manufactured for this mower.
ATTACHING/REMOVING THE MULCHING INSERT
WARNING: Do not at any time make any adjustment to the
lawn mower without first stopping the motor and removing the
safety key.
1. Lift the rear discharge door.
2. Grasp the handle of the mulching insert and fully insert it
into the mower so that it is securely seated (Fig. 10).
3. To remove the mulching insert, lift the rear discharge door,
grasp the handle of the mulching insert and pull it out.
4. Release the discharge door and make sure it rests firmly
against the mulching insert.
NOTICE: The mulching insert must be removed in order to install
and use the grass bag and must be re-installed when the grass
bag is removed.
16
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2000-S
9
Rear Discharge
Door
10
Hook