Assembly - Style For Life BS-1000 VibeRx User Manual

ASSEMBLY: You are now ready to assemble the Whole Body Vibration system. This usually
takes 2 people.
1. Connect the cable (20) inside the stand tube
(19) with the cable (21) inside the main base
unit (1); slide the stand tube (19) over the back
of the base unit (1). See Figure 1. Please Make
sure the wire connection is tight. Be careful not
to pinch the cable while sliding the stand
tube (19) on to the main unit. (1)
2. After your set the main tube on the main part,
you attach them by using the short bolts, flat
washers, and spring washers. Put the spring
washers on the bolts before the washers. Align
the corresponding screw holes. Use the
enclosed Allen wrench to secure the bolts. See
photo below to select the correct parts and
Figure 2 for the parts list.
3. Insert the parts of two handle bars (7) and (17)
together, aligning the four holes. Make sure the
connectors (8) and (16) are free and not
pinched. See Figure 3.
Style For Life Whole Body Vibration Owner's Manual • Page 4 of 14
Figure 1
Figure 2
Figure 3