Table of Contents
Advertisement
___________________________________________________________________________
b. Use electrical tape to secure the vertical element wire below the base tube
exit hole. If there is any slack in the vertical element wire, it should to be
left ABOVE the electrical tape. This way, there will be some slack wire
available to move with the fiberglass sections in the event of very strong
wind.
c. COMPLETELY weatherproof the vertical element wire connection and all
coax feed line and unun connections using the sealant of your choice such
as coax seal, silicon RTV, etc.
NOTE: It is not necessary to weatherproof the ring terminal
connections on the radial plate.
________________________________________________________________________
S9v 43' Installation Guide
Leave wire slack
above tape
16
Advertisement
Table of Contents
