___________________________________________________________________________
Do NOT over-
tighten screw s!
NOTE: The antenna should now be fully extended and laying on the
ground and all sections should be secured with the stainless
steel screws (except the top, tip section which does not require
a screw).
g. Place the provided black vinyl cap on the tip of the antenna.
h. As you extended and secured the sections, the vertical element wire may
have disappeared inside the bottom of the base tube. Now, let's retrieve
the vertical element wire from the base tube. Rotate the base tube until
you see the wire exit hole which is located about two feet up from the
bottom of the antenna.
i. Use the supplied hook tool to grab the wire and then gently twist the tool
clockwise to pull the loose (bottom) end of the wire toward the hole.
________________________________________________________________________
S9v 43' Installation Guide
12