Table of Contents
Advertisement
___________________________________________________________________________
6. Connect Antenna to Unun or Remote Antenna Tuner.
a. Position the 4:1 unun or remote antenna tuner at the base of the antenna
and connect the antenna vertical element wire ring terminal connector to
the unun stud marked Vertical (or tuner connection marked Antenna).
Next, solder two ring terminal connectors to a short piece of radial wire or
tinned copper braid and connect the unun Radials stud to any convenient
hole on the radial plate (or connect the remote antenna tuner Ground
connection to any hole on the radial plate). This lead should be kept as
short as possible. Finally, connect your coax feed line male PL-259
connector to the unun or remote antenna tuner female SO-239 connector.
Connect unun
Radials
stud to
radial plate
________________________________________________________________________
S9v 43' Installation Guide
Connect S9v
43' vertical
element wire to
Vertical
unun
stud
15
Advertisement
Table of Contents
