Yamaha CD-S2000 User Manual page 26

FCC INFORMATION (for US customers)
IMPORTANT NOTICE: DO NOT MODIFY THIS
UNIT!
This product, when installed as indicated in the
instructions contained in this manual, meets FCC
requirements. Modifications not expressly approved by
Yamaha may void your authority, granted by the FCC,
to
use the product.
2 IMPORTANT: When connecting this product to
accessories and/or another product use only high quality
shielded cables. Cable/s supplied with this product MUST
be used. Follow all installation instructions. Failure to
follow instructions could void your FCC authorization to
use this product in the USA.
3 NOTE: This product has been tested and found to comply
with the requirements listed in FCC Regulations, Part 15
for Class "B" digital devices. Compliance with these
requirements provides a reasonable level of assurance that
your use of this product in a residential environment will
not result in harmful interference with other electronic
devices.
This equipment generates/uses radio frequencies and, if
not installed and used according to the instructions found
in the users manual, may cause interference harmful to the
operation of other electronic devices.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
AVERTISSEMENT
L'utilisation de commandes et l'emploi de reglages ou de
methodes autres que ceux decrits ci-dessous. peuvent
en trainer une exposition
a
un rayonnement dangereux.
I I
~;y
~ ~
CLASS 1 LASER PRODUCT
LASER KLASSE 1 PRODUKT
LUOKAN 1 LASERLAITE
KLASS 1 LASER APPARAT
PRODUIT LASER DE CLASSE 1
Compliance with FCC regulations does not guarantee that
interference will not occur in all installations. If this
product is found to be the source of interference. which
can be determined by turning the unit "OFF" and "ON".
please try to eliminate the problem by using one of the
following measures:
Relocate either this product or the device that is being
affected by the interference.
Utilize power outlets that are on different branch (circuit
breaker or fuse) circuits or install AC line filter/so
In the case of radio or TV interference. relocatelreorient
the antenna. If the antenna lead-in is 300 ohm ribbon lead,
change the lead-in to coaxial type cable.
If these corrective measures do not produce satisfactory
results, please contact the local retailer authorized to
distribute this type of product. If you can not locate the
appropriate retailer, please contact Yamaha Electronics
Corp., U.S.A. 6660 Orangethorpe Ave., Buena Park, CA
90620.
The above statements apply ONLY to those products
distributed by Yamaha Corporation of America or its
subsidiaries.
CAUTION . VISIBLE AND / DR INVISIBLE LASER RADIATION WHEN OPEN
AVOID EXPOSURE TO BEAM
VARNING • SYNlIG DCH / ELLER DSYNlIG LASERSTRA1.NING NAR DENNA
DEL AR OPPNAD. STRALEN AR fARlIG
VAilO!
AVAnAESSA OLET ALnIlNA NAKYVALLE JA / TAl
NAKYMATOMA!.LE LAS£RsATEILYLLE ALA KATSO SATEESEEN.
VARNING . SYNlIG DGH / ELLER DSYNUG LASERSTRALNING NAR DENNA DEL
AR OP?NAO BETRAJ(]A EJ STRALEN
VORSICHT
I
SICHTBARE UNO / DOER UNSIGHTBARE LASERSTRAHLUNG
WENN ABDEGKUNG GEOFFNET. NIGHT OEM STRAHL AUSSETZEN.
ATIENTION . PADIATION VISIBLE ET I OU INVISIBLE LORSOUE L APPAREIL
EST OUVER!. EVITEl TOUTE EXPOSITION AU FAISCEAU.
0
0
~QP
~
~
0
CJ
~
0
D
CAUTION INVISIBLE LASER RADIATION WHEN OPEN
AND INTERLOCKS DEFEATED. AVOID EXPOSURE TO
BEAM.
ii
En