ALGE-Timing Timy Manual page 4

For example: Data-stream with 5 TIMYS:
MASTER-TIMY:
SLAVE:
SLAVE:
SLAVE:
SLAVE:
You can also configure the data-stream on another way:
Therefore you have to adjust all TIMYS as follows:
Now you can define the MASTER by pressing the OK-button at one TIMY.
Normally is every TIMY, which is connected to a PC, the MASTER.
You can also define MASTER, if the PC sends the command „TERLIST<cr>" to the
MASTER-TIMY.
Thereupon the MASTER-TIMY will start with the numbering.
(TERLIST, TER=TERMINAL, LIST=GET LIST)
If the MASTER-TIMY retrieved all SLAVES, the numbering starts. You must one time
manually assign to every SLAVE one number. The MASTER sends to all TIMYS e.b. "ARE
YOU NUMBER 04 ?" You have to press the OK-button at the Timy which is spoken to.
Go on like that until all TIMYS (including MASTER) are numbered.
Reconnection (= next implementing) :
If the data-stream was correctly configured once, the MASTER-TIMY will start automatically
with the buildup of the data-stream and can receive commands of the PC immediately.
Page 4
Timy
->ADRESS = 01
->ANZ. SLAVES = 04
->ADRESS = 02
->ANZ. SLAVES = 0
->ADRESS = 03
->ANZ. SLAVES = 0
->ADRESS = 04
->ANZ. SLAVES = 0
->ADRESS = 05
->ANZ. SLAVES = 0
->ADRESSE = 0
->ANZ. SLAVES = 0
Terminal