Oki C910 Troubleshooting Manual page 20

* COLOR Setting
Note
When COLOR is on, if [ONLINE] is pressed, the settings below will appear and the print
color-setting mode will be entered.
COLOR
Y:ON M:ON
Press [ENTER] to move the cursor to the color to be turned on or off.
Press [MENU+] or [MENU-] to turn the setting of each color on or off, respectively[OK to
add?].
Press [BACK] to exit the print color-setting mode.
* FINISHER Setting
(1) When "FINISHER" is shown at the bottom of the display panel, press [ENTER].
(2) Press [MENU+] or [MENU-] until the setting item to be edited appears.
(3) Press [ENTER]; the set value will appear at the bottom of the panel.
Press [MENU+] or [MENU-] until the desired value appears. ([MENU+] increases the
value and [MENU-] decreases the value.)
(4) Press [BACK] to return to step (2) above. Press [BACK] again to return to step (1).
(5) Repeat steps (2) to (4) as necessary.
Display
OUTPUT BIN FACE DOWN
FINISHER UPPER BIN
FINISHER LOWER BIN
PUNCH OFF
ON
OFFSET OFF
ON
STAPLE MODE OFF
Rear
Center
Front
Saddle
STAPLE NUMBER 0
INVERT OFF
ON
4. Operations in section 2 will execute test printing at the set value that is set in Steps 2
to 3, by pressing the [ENTER] key when the state displays "PRINT EXECUTE" at the
bottom row of the display.
Press the [ENTER] key to stop test printing.
C:ON K:ON
The settings shaded in
Setting value
Printer face down
Finisher upper bin
Finisher lower bin
Punch on/off
Offset on/off
Staple mode off
Rear corner
Center corner
Front corner
Saddle stitch
Set the number of sheets to be stapled (0 to 50).
* When the staple mode is on, ÅgSTAPLE NUMBERÅh is
selectable between 2 and 50.
Invert on/off
Troubleshooting Guide Page 20
are default settings.
Function