Connect The Wiring; Install The Hood; Complete Installation; Install Light Bulbs - Broan AP1 series Manual

:: ::
rangehoods.com rangehoods.com
DAMPER /
DUCT
CONNECTOR
5 Remove Vertical Duct Knockout or Horizontal Duct
Knockout and attach Damper / Duct Connector with
two (2) screws (supplied).

INSTALL THE HOOD

WARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
MOUNTING
SCREWS (4)
6 Run House Power Cable between service panel and
hood location. Attach power cable to hood using appropri-
ate connector.
7 Hold the hood in position under the cabinet. Make sure
the damper / duct connector enters the Ductwork and
that the damper opens and closes freely.
8 Tighten the four (4) Mounting Screws completely to se-
cure the hood to the cabinet.
Call 1-800-667-8721 anywhere in the US and Canada Call 1-800-667-8721 anywhere in the US and Canada
VERTICAL DUCT
KNOCKOUT
HORIZONTAL DUCT
KNOCKOUT
HOUSE
POWER
CABLE
DUCTWORK
:: rangehoods.
Broan at

CONNECT THE WIRING

HE0059
9 Connect House Power Cable to range hood wiring
- BLACK to BLACK, WHITE to WHITE, and GREEN or
BARE WIRE to GREEN Ground Screw.

COMPLETE INSTALLATION

were removed in Step 3.

INSTALL LIGHT BULBS

11 Install Halogen Bulbs. Use 120 V, 50 W, shielded halo-
gen bulbs - MR16 or PAR16 with GU10 base. Purchase
bulbs separately.
1
com
kitchen
is a division of
U N
- - www.rangehoods.com www.rangehoods.com
AP1 & RP SERIES
GREEN
GROUND
SCREW
HOUSE
POWER
CABLE
(1) PUSH IN
(2) ROTATE
CLOCKWISE
accessories
::
L I M I T E D
Page 4