Table of Contents
Advertisement
Connect the Wiring
Risk of electric shock. Electrical wiring must be done by qualifi ed
personnel in accordance with all applicable codes and standards.
Before connecting wires, switch power off at service panel and lock
service disconnecting means to prevent power from being switched
on accidentally.
1 ] Connect House Power Cable to range hood wiring: BLACK to BLACK, WHITE to WHITE and
GREEN or bare wire under GREEN ground screw.
2 ] Reinstall the blower cover plate (shaded part on illustration below) using the lock nut
and 7 screws previously removed in steps 4 and 7 on page 10. Pay attention to screw 1
location; from back of hood point of view, it must be located on right side of the lock nut (see
inset).
3 ] Reinstall the fillers by following steps as illustrated below.
!
WARNING
HOUSE
POWER CABLE
5
6
7
BACK OF HOOD
LOCK NUT
MOTORS
GROUND
WIRE
GROUND
SCREW
4
3
2
1
1
21
Advertisement
Table of Contents
