Cleaning And Maintenance; Operation; Prepare Hood Location - Broan AP1 series Manual

:: ::
rangehoods.com rangehoods.com
CLEANING & MAINTENANCE
fan and grease-laden surfaces. Use only a clean cloth and mild
detergent solution on stainless and painted surfaces. Clean all-
The motor is permanently lubricated and never needs oiling. If
be replaced.
Use 120 V, 50 W, shielded halogen bulbs - MR16 or PAR16 with
GU10 base. Purchase bulbs separately.
cleaned frequently. Use a warm detergent solution. The grease
oration is not covered by the warranty.

OPERATION

Always turn the hood ON before cooking in order to establish an
for a few minutes to clear the air.
HEAT SENTRY™
The hood is equipped with a Heat Sentry™ thermostat. This safety
above the cooking surface.
If the blower is not on, or if it is running at low speed, the Heat
Senttry™ will override the normal blower control and trun the
blower on the high speed. When the temperature level drops to
normal levels, the blower will return to its original setting.
RP SERIES HOOD
BLOWER SWITCH
This 3-position switch turns blower ON and OFF and controls
blower speed.
Set switch to (1) position to turn blower ON to low speed.
Set switch to (2) position to turn blower ON to high speed.
Set switch to (0) position to turn blower OFF.
LIGHT SWITCH
This 3-position switch turns lights ON and OFF and controls
their intensity.
Set switch to (1) position to turn lights ON to low intensity.
Set switch to (2) position to turn lights ON to high intensity.
Set switch to (0) position to turn lights OFF.
Call 1-800-667-8721 anywhere in the US and Canada Call 1-800-667-8721 anywhere in the US and Canada
-
:: rangehoods. com
Broan at
AP SERIES HOOD
FAN
FAN
The 2-position switch (in center) turns blower ON and OFF.
The 5-position switch (at left) controls blower speed.
Blower is OFF (secondary blower OFF).
Blower is ON at highest speed.
As dots get smaller - blower speed decreases.
LIGHT
This 3-position switch (at right) turns lights ON and OFF and
controls their intensity.
Lights are OFF.
Lights are ON to low intensity.
Lights are ON to highest intensity.

PREPARE HOOD LOCATION

ROOF CAP
SOFFIT
CABINET
HOOD HOOD
18" - 24" ABOVE
COOKING SURFACE
hood location and a roof cap or wall cap. For best results,
use a minimum number of transitions and elbows.
1
accessories
::
kitchen
is a division of
U N L I M
- - www.rangehoods.com www.rangehoods.com
AP1 & RP SERIES
Page 2
ON FAN OFF
LIGHT
3¼" X 10" or
7" ROUND DUCT
(For vertical
discharge)
HOUSE WIRING
(Top or Back of hood)
WALL CAP
3¼" X 10" DUCT
(For horizontal discharge
I T E D
-