Pride Mobility JET 3 Ultra Owner's Manual page 18

I I I .
ELECTRICAL COMPONENTS
The electrical components are located on the power base. The ammeter and the onboard battery charger AC power lead
receptacle are located on the right side of the power base. The main circuit breaker is located on the front of the battery
tray. The charger inhibit and the motor connectors are located on the power pod, inside the power base. See figure 7.
Ammeter: The ammeter displays the charger’s current output in amps. See VI. “Batteries and Charging.”
Onboard Battery Charger AC Power Lead Receptacle: This is where the AC power lead plugs into the onboard
charger. See VI. “Batteries and Charging.”
Main Circuit Breaker: The main circuit breaker is a safety feature built into your power chair. When the batteries and the
motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to the motors and
the electronics. If the circuit trips, allow your power chair to “rest” for approximately one minute. Next, push in the circuit
breaker button, turn on the controller, and continue normal operation. If the main circuit breaker continues to trip repeat-
edly, contact your authorised Pride Provider.
Motor Connectors: This is where the controller connects to the motors. The motor connectors are colour-coded with
red and yellow labels. The label colour on the motor connector corresponds with the label colour on the power pod.
Battery Connector: This is where the controller connects to the batteries.
Charger Inhibit Connector: The charger inhibit enables the onboard charger to disable the controller during charging.
See VII. “Operation.”
CHARGER INHIBIT
CONNECTOR
MOTOR CONNECTOR
POWER POD
ONBOARD BATTERY
CHARGER AC POWER
LEAD RECEPTACLE
AMMETER
MAIN CIRCUIT BREAKER
Figure 7. Jet 3 Ultra Electrical Components
18
T H E
BATTERY CONNECTOR
MOTOR CONNECTOR
www.pridemobility.com
J E T 3 U L T R A
CHARGER CIRCUIT FUSE
ONBOARD BATTERY CHARGER
Jet 3 Ultra