Troubleshooting - Omron E2 ELITE Instruction Manual

3.Maintenance

3.3 Troubleshooting

Problem
 The power cannot  The batteries are wrongly inserted.
be switched on.
 The pads are not properly attached to the
 The power switches
 The pads are removed from the skin·
off to soon.
 The power switches
 The batteries are worn out or empty.
off while the unit is
 The power turns automatically off after 15
in use.
 The electrode cord is broken.
 The clear film on the adhesive surface of
 The adhesive surface of the pad is dirty.
 The pads do not
 The pads are used directly after washing
attach to the skin.
 The adhesive surface of the pads is
 The pads may have been used while
 The pads may have been washed too long
 The pads may have been stored under
 The pads are not in close contact with the
 The stimulating
 The pads are attached, but overlapping
effect cannot be felt.
 The electrode cord is not connected
 The intensity is at a too low level.
 The batteries are worn out or empty.
 The adhesive surface of the pads is
 The treatment has continued too long.
 The pads are not in close contact with the
 The skin turns red.
 The skin feels
 The adhesive surface of the pads is dirty or
irritated.

* If the unit does not operate after taking the above-mentioned measures, contact the nearest OMRON dealer.
16
Cause
skin.
minutes.
the pad has not been removed.
them.
damaged.
perspiring.
and too frequently.
high humidity, high temperature or in direct
sunshine.
skin.
each other.
properly.
damaged.
skin.
dry.
The adhesive surface of the pads is
damaged.
Remedial Action
 Insert the batteries according given directions.
 Reattach the pads securely to the skin. (Otherwise
power will switch off automatically).
 Switch off the unit before removing the pads from the
skin.
 Replace with new batteries, following given directions.
 Replace the electrode cord with a new one.
 Remove the film.
 Clean the pads, following given directions.
 After washing, allow the pads sufficient time for
drying.
 Replace the pads with new ones.
 Leave the pads in a refrigerator overnight.
 Reattach the pads to the skin properly.
 Reattach the pads to the skin while assuring they do
not overlap.
 Connect the electrode cord properly.
 Increase the intensity.
 Replace the batteries with new ones, following
direction given.
 Replace the pads with new ones.
 Limit the treatment time to the programmed 15
minutes.
 Reattach the pads to skin properly.
 Wash the pads, following given directions.
 Replace the pads with new ones.