Power Tech Generators PTSMH-15 Operator's Manual page 8

ESCAPING FLUIDS
• Relieve all pressure in the air, oil and cooling systems
before any lines, fittings or related items are removed or
disconnected.
• Be alert for possible pressure release when disconnecting any device
from a system that is pressurized. DO NOT check for
pressure leaks with your hands. High-pressure oil or fuel can
cause personal injury.
• Escaping hydraulic fluid under pressure has sufficient force to
penetrate skin causing serious personal injury.
• Fluid escaping from pinholes may be invisible. Use a piece of
cardboard or wood to search for suspected leaks: do not use
hands and body. Use safety goggles or other eye protection
when checking for leaks.
• If injured by escaping fluid, see a medical doctor immediately.
This fluid can produce gangrene or severe allergic reaction.
CAUTIONS AGAINST BURNS AND BATTERY EXPLOSION
To avoid burns, be alert for hot components during operation and
•
just after the engine has been shut off. Such as the muffler, muffler
cover, radiator, piping, engine body, coolants, engine oil, etc.
• DO NOT remove the radiator cap while the engine is running or
immediately after stopping. Wait approximately ten minutes for the
radiator to cool before removing the cap.
• Be sure the radiator drain valve / petcock and hose clamps are
tighten. Check radiator pressure cap and oil fill cap before operating
the engine.
• The battery presents an explosive hazard. When the battery is
being activated, hydrogen and oxygen gases are extremely explosive.
• Keep sparks and open flames away from the battery, especially
during charging. DO NOT strike a match near the battery.
• DO NOT check a batteries charge by placing a metal object across
the terminals. Use a voltmeter or hydrometer.
• DO NOT charge a battery if frozen, it may possibly explode. Frozen
batteries must be warm up to at least 61°F (16°C) before charging.
KEEP HANDS AND BODY AWAY FROM ROTATING PARTS
• Keep your hands and body away from all rotating parts, such
as cooling fan, v-belts, pulleys and flywheel. Contact with these
rotating parts can cause serious personal injury.
• Be sure to stop the engine before adjusting belt tension or checking
the cooling fan.
• DO NOT run the engine without safety guards installed. Be sure the
safety guards are properly aligned and securely fastened before operating
the engine.
3