Generator Installation - Power Tech Generators PTSMH-15 Operator's Manual

Hide thumbs

Table of Contents

Use this section as a guide when installing a generator set in a recreational vehicle, and then refer

to the appropriate operation section for specific instructions. When installing a RV generator set the

installation must comply with current standards of ANSI / RVIA EGS-1, ANSI A 119.2 / NFPA 501C,

and applicable articles of ANSI / NFPA 70 of the National Electrical Code. Generator set installations

must also comply with state and local requirements.

RV generator sets do not comply with United States Coast Guard (USCG) requirements and

must not be used for marine applications. Use only generator sets specified for marine use in marine

installations. USCG regulation 33CFR183 requires a generator set to be "ignition protected" when used

in a gasoline fueled environment.

This information section covers the RV generator set models listed below. To determine which

model is involved, check the model number found on the Power Technology nameplate attached to the

frame of the generator being installed. Follow all instructions to ensure proper installation and operation.

Each generator set features a Kubota diesel engine, rotating-field alternating current generator,

and a relay controller. The generator is directly connected to the engine for permanent alignment. Each

controller includes a Start / Stop switch for test operating the set at the controller. Also included is an On

/Off switch to reset the controller or lockout any remote switch to prevent starting while service is being

performed. The controller may be equipped with a switch to operate the mechanism used to move the

generator out of the coach for servicing. (Supplied by the coach manufacture). After the set is attached

to the frame of the vehicle, all that is usually required to make it operational is the following.

1. Attaching the exhaust system.

2. Add proper amount of radiator coolant.

3. Add oil to crankcase, to the dipstick FULL mark.

4. Connect fuel lines, remote switch, load leads and battery terminals.

(Consult the Specification Charts on the Following Pages for Requirements)

MODEL

GENERATOR DIMENSIONS L x W x H

WEIGHT

ENGINE

RPMs

KW RATING

AC VOLTAGE

AMPERAGE

PHASE

GENERATOR COMPARTMENT

FREE AIR OPENING

RADIATOR AIR REQUIREMENTS