Intercom-To-Phone; Pairing Intercom Channels “A” And “B”; Cardo Gateway - scala rider PACKTALK User Manual

INTERCOM-TO-PHONE

In Bluetooth Intercom mode, if a "1+8" Buddy is not in range, or moves out of range, you
have the option to set up the "Intercom-to-Phone" feature via the Cardo Community, to
remain in contact by diverting Intercom calls automatically to your mobile phones.
INTERCOM WITH CHANNELS "A" AND "B"
5.2b
Start multi-party conversations using Intercom Channels "A" and "B". This mode is
suitable for 2, 3 or 4-way calls.
PAIRING INTERCOM CHANNELS "A" AND "B"
Pairing a channel will replace any existing paired device on that Channel with the
newly paired device.
If you have purchased the PACKTALK DUO, both units are factory-paired and configured to
communicate via Channel "A". If for any reason you have to pair them again, OR if you wish to
pair a different unit to make Intercom calls, proceed as follows:
There are three ways to pair Intercom (IC) Channels "A" and "B":
 OPTION 1: Advanced Features Menu
1. Make sure your unit is in Bluetooth Intercom mode and in Standby.
2. Double-tap to enter the Advanced Features Menu (see 3.3).
Z
3. Select either "Pair Intercom Channel A" or "Pair Interom Channel B".
☛
OPTION 2: Manual Pairing
1. Check that all units are in Standby.
2. To pair IC Channel A – press
flashing rapidly.
To pair IC Channel B – press
flashing rapidly. Then double-tap
pairing mode.
3. Enter IC Pairing mode on the second unit following its user manual. Both units
will now be in Intercom Pairing mode.
4. After a few seconds, both units will show a solid LED for 2 seconds, indicating that
they are paired and ready to use.
5. If Pairing is not completed within 2 minutes, the units will return to Standby mode.
g
OPTION 3: Via the Cardo SmartSet App (see 3.2)
G

CARDO GATEWAY

Non-Cardo devices can connect via the "Cardo Gateway", allowing conversation
between your PACKTALK and a non-Cardo brand of Bluetooth intercom.
There are two ways to pair with a non-Cardo brand of Bluetooth intercom:
 OPTION 1: Advanced Features Menu
Enter the Advanced Features Menu (see 3.3) and select "Cardo Gateway" to enter
pairing mode on the scala rider.
☛
OPTION 2: Manual Pairing
Enter Intercom Channel "B" pairing mode (see above) and tap p.
Next, enter Mobile Phone Pairing mode on the second unit following its user manual.
After a few seconds, both units will show a solid LED for 2 seconds, indicating that they
are paired.
If Pairing is not completed within 2 minutes, the units will return to Standby mode.
for at least 5 seconds until the RED LED begins
v
for at least 5 seconds until the RED LED begins
v
. A flashing BLUE LED indicates Channel "B"
v
|
13