Unpairing An Accessory - Mitel 5320e User And Administrator Manual

5320e/5330e/5340e SIP User and Administrator Guide
2. Press and hold the pairing button on the back of the Bluetooth Module for 5 seconds to
activate phone pairing mode. The LED on the Bluetooth Module blinks. The Cordless Devices
application opens on the phone and prompts you to place the accessory in pairing mode.
3. For Mitel Bluetooth Handsets: Press and hold the hookswitch on side of the Bluetooth
Handset for 5 seconds to activate accessory pairing mode. The LED on the handset blinks.
The pairing confirmation window on the IP Phone appears, displaying the product name for
the device to be paired.
Note: If the LED on the handset does not start to blink after 10 seconds, the handset
requires charging or is still in factory battery saving mode. Place the handset on the
charger. The green LED starts to flash indicating that the handset is charging. It could
take up to 60 minutes for the green LED to stop flashing. Allow the handset to fully
charge, approximately 3 hours.
For third-party Bluetooth headsets: Follow the manufacturer's instructions to place the
Bluetooth headset in pairing mode. The pairing confirmation window on the IP Phone
appears, displaying the product name for the device to be paired.
4. Press Yes to confirm the pairing. The Cordless Devices application prompts you to enter a
passcode.
5. Enter a valid passcode for the Bluetooth device (default is 0000) using the keyboard on the
display, and press OK.
For third-party Bluetooth headsets: An Auto Connect window displays. Press Yes if the
phone will not be shared with other users; press No if the phone will be shared with other
users and multiple headsets.
6. The LED on the Bluetooth Module lights and remains lit for a few seconds and then resumes
normal behavior. The Bluetooth device is paired to the Bluetooth Module.
7. Press OK to return to the Cordless Devices application.
8. Press Close to exit the application.

Unpairing an Accessory

To unpair a cordless accessory:
1. Press the blue Menu
2. Press the device name that you want to unpair. The information screen for the selected
device appears.
3. Press Unpair this Device. If the accessory is in use, an error message is displayed.
Otherwise, the accessory is unpaired, removed from the display, and can no longer be used
to interact with the phone.
4. Press Close.
For more information about the Cordless Devices Application, see page 55.
key and then press Cordless Devices.
- 46 -