Advertisement
Air Outlet Duct
G
To improve air distribution in a room it is possible to divide the air outlet into the room. This is acheived by
adding a distribution duct. Only one duct can be used per unit.
G
Before installing the unit remove the cut out hole and fit a spigot to connect the duct before hanging the unit.
(1) The cut out hole is a rectangular shape half-cut hole located on two sides of the unit.
GB
(2) Carefully cut through the slots of the rectangular shape with a knife ensuring the blade does not penetrate
(3) Cut the 4 metal tabs to remove the rectangular metal part and the thermal insulator from the
(4) Add a spigot to the side of the indoor unit and attach using the 6 screw holes as shown below:-
(5) Add thermal insulation around the spigot to eliminate the possibility of condensation forming on the
I
U
L
NDOOR
NIT
OCATION
Details of Cut Out Hole
more than 30mm.
indoor unit.
Air Outlet Spigot (ø150)
metal surfaces.
~ 22 ~
Air Outlet Duct
Thermal Insulator
Metal
6-ø6
80
10
30
6
Advertisement
