The Installation & Connection flow is shown as the following figure.
Install the switch to the
specified position
Connect to the ground
Install the Power Supply Module
Install Interface Card?
Install the Interface Card
Verify installation
Power on via Power
Connect to SFP/SFP+
transceivers and cables
Also power on via
Connect to RPS
Figure 2-1
Installation & Connection Flow
Note: The switch can be powered by the Power Supply Module and Redundant Power
Supply simultaneously or individually. If simultaneously, the Power Supply Module and
Redundant Power Supply together will enable your network to enjoy the benefit of
uninterrupted operation.
Start
No
Yes
Supply Module
No
RPS?
Yes
End
Stackable L3 Managed Switch
08
Preparing For Installation