TP-Link T3700G-28TQ Installation Manual page 10

Stackable L3 Managed Switch
03
Introduction
Port Feature
10/100/1000Mbps
Model
RJ45 Port
T3700G-28TQ
10/100/1000Mbps Port
Port 1-24, designed to connect to the device with a bandwidth of 10Mbps, 100Mbps
or 1000Mbps. Each has a corresponding 10/100/1000Mbps LED.
SFP Port
Port 21F-24F, designed to install the SFP transceiver. These four SFP transceiver slots
are shared with the associated RJ45 ports. The associated two ports are referred as
a "Combo" port, which means they cannot be used simultaneously, otherwise only
SFP port works.
SFP+ Port
Port 25-26, designed to install the 10Gbps SFP+ transceiver or SFP+ cables.
T3700G-28TQ also provides an interface card slot on the rear panel to install the
expansion card (TX432 of TP-LINK for example1. If TX432 is installed, you get
another two 10Gbps SFP+ ports.
Unit ID LED
Designed to display the stack unit ID of the switch. For the switch that does
not join any stack system, it displays its default unit ID. To modify the default
unit number, please logon to the GUI of the switch and go to Stack→Stack
Management→Switch Renumber page.
Rear Panel
■
The rear panel of T3700G-28TQ is shown as the following figure.
Interface Card Slot
Grounding Terminal
RPS Input Connector
Power Supply Module
Figure 1-2
Note: The Interface Card Slot, RPS Input Connector and AC Power Supply Module Slot
are shipped with protective covers.
Interface Card Slot
Designed to extend the interfaces. You can select an Interface Card (TX432 of TP-
LINK for example1 for your switch if needed. For how to install an Interface Card,
please refer to 3.4 Installing & Removing the Interface Card.
Console 1000Mbps
Port SFP Port
24 1 4(Combo1
Rear Panel of T3700G-28TQ (11
10Gbps SFP+
Port
4 (2 fixed + 2
optional1