TP-Link T3700G-28TQ Installation Manual page 11

Grounding Terminal
The switch already comes with lightning protection mechanism. You can also ground
the switch through the PE (Protecting Earth1 cable of AC cord or with Ground Cable.
For detailed information, please refer to Chapter 4 Lightning Protection.
RPS Input Connector
Designed to connect the RPS (Redundant Power Supply1. You can selected an RPS
(RPS150 of TP-LINK for example1 for your switch if needed. For how to install an
RPS, please refer to 5.6 Power on via Redundant Power Supply.
Power Supply Module
The AC Power Supply Module PSM150-AC is provided with the switch. It is fully
hot swappable, helping to ensure no system interruption during installation or
replacement. For how to install/remove the Power Supply Module, please refer to 3.3
Installing & Removing the Power Supply Module.
Caution: Please use the provided power cord.
With all the protective covers removed, and the Interface Card (TX4321 & Power Supply
Module (PSM150-AC1 inserted, the rear panel of T3700G-28TQ is shown as the following
figure.
Figure 1-3 Rear Panel of T3700G-28TQ (21
Stackable L3 Managed Switch
04
Introduction