Replacing Light Bulbs - Toyota Camry Quick Reference Manual

carownersmanual.net
carownersmanual.net

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
The high mounted stoplight consists of a
number of LEDs. If any of the LEDs burn
out, take your vehicle to your Toyota deal-
er to have the light replaced.
D
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
D
Halogen bulbs have pressurized gas
inside and require special handling.
They
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
Only use a bulb of the listed type.
400
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled
CAUTION
Toyota dealer.
can burst or shatter if
NOTICE
'07Camry_U (L/O 0608)
like the
inside the light, contact your
2007MY CAMRY from Oct. '06 Prod. (OM33748U)
Bulb
Light bulbs W Type
No.
Headlights
9005 60 A
(high)
Headlights (low) — 55 B
Front side
— 5 C
marker lights
Front turn
signal/parking 3457NAK 30/8 D
lights
Rear turn signal
— 21 D
lights
Stop/tail and
7443 21/5 C
rear side
marker lights
Tail lights
— 5 C
(type A)
Tail lights
194 3.8 C
(type B)
License plate
— 5 C
lights
Back−up lights 921 16 C
Front fog lights — 55 B
Front personal
— 5 C
lights