Toyota Camry Quick Reference Manual page 291

carownersmanual.net
carownersmanual.net
(c) Erasing
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
For additional programming assistance
with
Transceiver call the:
D
Toyota Customer Experience Center at
1−800−331−4331 (U.S.A.)
D
Toyota
Centre at 1−888−869−6828 (Canada)
274
Refer to HomeLink
WWW.HOMELINK.COM
R
the entire HomeLink
R
R
your HomeLink Universal
Canada Customer Interaction
'07Camry_U (L/O 0608)
R
on the internet at:
CAUTION
D
When programming the HomeLink
Universal Transceiver, you may be
operating a garage door or other
device. Make sure people and ob-
jects are out of the way of the ga-
rage door or other device to pre-
vent potential harm or damage.
D R
Do not use this HomeLink Univer-
sal Transceiver with any garage
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
(This includes any garage door
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
(signaling the door to stop and re-
verse), does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
This device complies with Part 15 of the
FCC Rules and with RSS−210 of the IC
Rules. Operation is subject to the fol-
lowing two conditions: (1) This device
may not cause harmful interference, and
R
(2) this device must accept any interfer-
ence received, including interference
that may cause undesired operation.
WARNING: This transmitter has been
tested and complies with FCC and IC
rules. Changes or modifications not
expressly approved by the party re-
sponsible for compliance could void
the user's authority to operate the
device.
2007MY CAMRY from Oct. '06 Prod. (OM33748U)