Toyota Camry Quick Reference Manual page 290

carownersmanual.net
carownersmanual.net
6. Repeat steps 2 through 5 for each re-
maining HomeLink
another device.
Programming a rolling code system
If your
equipped,
steps 1 through 4 under the heading
"Programming the HomeLink
proceeding with the steps listed below.
1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
door
guide supplied by the garage door
opener manufacturer for the location of
this "training" button.
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
3. Press and release the vehicle's pro-
grammed HomeLink
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.
The ceiling mounted garage door opener
R
button to program motor
HomeLink
garage door up/down.
4. Repeat steps 1 through 3 for each re-
device is "Rolling Code"
it is necessary to follow
R
" before
Programming an entrance gate/program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
2. Place
opener. Refer to the owner's
Keep the indicator light on the HomeLink
in view while programming.
3. Press
4. Continuously press and release (cycle)
R
button twice. The
5. When
'07Camry_U (L/O 0608)
should now recognize the
R
unit and be able activate the
R
maining HomeLink button to program
another rolling code system.
R
but-
tons you want to program.
your hand−held gate/device
transmitter 25 to 75 mm (1 to 3 in.)
away from the surface of the
R
HomeLink .
R
and hold the selected
R
HomeLink button.
the hand−held gate/device transmitter
button every two seconds until step 5
is complete.
the indicator light on the
R
HomeLink changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
6. Test the operation of the HomeLink
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
R
maining HomeLink button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
R
Individual HomeLink buttons cannot be
erased, however, to reprogram a single
button, follow the procedure "Programming
R
the HomeLink ".
R
(b) Operating the HomeLink
R
To operate the HomeLink , press the
R
appropriate HomeLink button to activate
the programmed device. The HomeLink
indicator light should come on.
R
HomeLink continues to send the signal
for up to 20 seconds as long as the
button is pressed.
2007MY CAMRY from Oct. '06 Prod. (OM33748U)
R
by
R
The
273