Archer CR700
Step 6: Press and hold the WPS button of the client device directly.
Step 7: The WPS LED flashes for two minutes during the Wi-Fi Protected Setup process.
Step 8: When the WPS LED is on, the client device has successfully connected to the modem
router.
Refer back to your client device or its documentation for further instructions.
IV. Enter the client device's PIN on the modem router
Use this method if your client device has a Wi-Fi Protected Setup PIN number.
Step 3: Enter the PIN number from the client device in the field, as shown in the following figure.
Then click Connect button.
Step 4: "Device has been added successfully!" will appear on the screen, which means the
client device has successfully connected to the modem router.
Note:
1)
The WPS LED on the modem router will light green for five minutes if the device has been
successfully added to the network.
2)
The WPS function cannot be configured if the Enable Router's PIN switch is off. Please
make sure the Enable Router's PIN switch is on before configuring the WPS.
5.5.3 Guest Network
Choose menu "Advanced→ Wireless 5G → Guest Network", you can configure the advanced
settings of your guest network.
C1750 Wireless Dual Band DOCSIS 3.0 Cable Modem Router User Guide
Figure 5-28
Figure 5-29
54