Panasonic SH-ALL1C Owner's Manual page 28

The network indicator does not stop blinking in blue and red.
≥ The unit needs to be repaired. Consult your dealer.
This unit has stopped producing operation sounds.
≥ Set the operation sound setting to on. (l 25)
Firmware updates
The mode indicator (amber) keeps blinking twice.
≥ This unit is not connected to the network. Touch any switch, and then
check the network connection. (l 12)
The mode indicator (amber) keeps blinking three times.
≥ The update has been failed. Touch any switch, and then try again.
The mode indicator (amber) keeps blinking fast.
≥ An error has occurred. Disconnect the AC power supply cord (AC mains
lead) and reconnect it. Turn the unit on and try again.
Network
The network indicator (red) keeps blinking.
≥ This unit is not connected to the network. Check the network
connection. (l 12)
Cannot connect to the network.
≥ This unit's Wi-Fi security supports WPA2
that provides a WPA2
the router, refer to the operating instructions of the router.
≥ If the network is set to be invisible, make the network visible while you
set up the network for this unit or make a wired LAN connection. (l 17)
≥ Make sure that the multicast function on the wireless router is enabled.
≥ Depending on the routers, WPS button may not work. Try other
methods. (l 12)
connection. For details on security supported by
TM
- 28 -
only. Use a wireless router
TM