Advertisement
LED Indicators
LED
Color
Green
Network
Amber
Unlit
Status
Power
Green
Note: Steady green and red during booting. Flash green and red during factory default.
2. Installation
For the operation of the Network Camera, it is necessary to connect a network cable for
data transmission, power connection from supplied power adapter and connect a general
analog camera. Depending on operation methods, it is possible to connect an alarm cable
or audio cable additionally. For its fixation on different locations, please consult with an
installer.
Network Connection
The Network Camera supports the operation through the network. Therefore, it is
necessary to connect a standard RJ-45 cable to it. Generally a cross-over cable is used for
directly connection to PC, while a direct cable is used for connection to a hub.
IP Assignment
When a camera, Encoder or Decoder is first connected to the network it has no IP address.
So, it is necessary to allocate an IP address to the device with the "Smart Manager" utility
on the CD.
1. Connect the Network Camera / device to the network and power up.
2. Start SmartManager utility ( All Programs> NautilusClient16 > SmartManager), the
main window will be displayed, after a short while any network devices connected to
the network will be displayed in the list.
Steady for connection to a 100 Mbit/s network. Flashes for
network activity.
Steady for connection to 10 Mbit/s network. Flashes for
network activity.
No network connection.
Red
Steady red for failed upgrade or booting.
Steady green for normal operation or booting.
Flashes green during firmware upgrade.
Indication
4
Advertisement
