Checking '0' Position Of Each Hand - Citizen Movement Caliber C660 Setting Instructions Manual

4. SWITCHING THE MODE (DISPLAY FUNCTIONS)
In addition to the time and date modes, this watch is also equipped with three a
race timer, chronograph, countdown timer as well as alarm 1 and alarm 1. The mode
can be switched by turning the crown. Check the current mode with the mode hand.
<Switching the Mode>
TME
Time
Set
Zone Setting
5. CHECKING O-POSITION OF EACH HAND
Before using this watch, check that the 0-position (based position of each hand)
is set correctly to ensure that the functions of the watch operate properly by
performing the following procedure.
<O-Position Check>
Return to Table of Contents
CAL
Calendar
AL-2
Alarm 2
1. Turn the crown while in the normal
position to set the mode hand to the
chronograph [CHR) mode.
2. Pull the crown out to the first click (O-
position correction position). The
second, minute, hour, 24-hour and
Function hands rapidly advance to the 0-
position (12:00 position).
Note:
When each hand is not at the 0-position,
perform the "O-position correction"
procedure. If this 0-position is out of
alignment, each hand will not indicate the
correct position.
Return to Table of Contents
RACE
Race Timer
AL-1
Alarm 1
CHR
Chronograph
TMR
Timer