ViewSonic PJ513D-1 Service Manual page 48

(1) Overfill Horizontal
Adjustment Screw
6. Assembly HSG ILL Module
6.1 FM1 Assembly
I. FM1 must be placed on datum surfaces well and breach of FM1 must be face to inside
(Fig. 6-1)
II. Insert the" CLIP of FM1" into the hole on the HSG ILL and make sure " CLIP of FM"
hook on the HSG ILL well (Fig. 6-2)
6.2 CM Assembly
III. Insert Clip CM Side and Clip CM Bottom first (Fig. 6-3,6-5)
IV. Assemble CM to HSG ILL and to make CM contact three datum on the HSG ILL
Well (Fig. 6-8)
V. Assemble "CLIP of TOP" to the HSG ILL (Fig. 6-9)
VI. To check and make sure " CLIP of CM" hooks the HSG ILL very Well (Fig.
6-4, 6-6,6-10)
VII. Assemble Baffle Stop to HSG ILL and fasten screw (Fig. 6-10)
VIII. Paste Sponge tube AL on cannelure of HSG ILL(Fig. 6-11)
ViewSonic Corporation
Pre-assy this screw not over
the side surface.
Fig. 5-10
45
Confidential - Do Not Copy
(2) Overfill Vertical
Adjustment Screw
Pre-assy this screw not over
the bottom surface.
PJ513D-1